ASTM D903-1998(2004) 胶粘剂抗剥落或剥离强度的试验方法

上一篇: ASTM D2557-1998(2004) 温度为-267.8至-55℃(-450至-67°F)范围内用拉力负荷法测定胶粘剂剪切强度的试验方法
下一篇: ASTM F702-1998a(2003) 医用聚砜树脂标准规范

【英文标准名称】:Opticalfibrecables-Indoorcables-Familyspecificationformulti-fibreopticaldistributioncables
【原文标准名称】:光缆.室内光缆.多光纤配电光缆的类规范
【标准号】:BSEN60794-2-20-2003
【标准状态】:作废
【国别】:英国
【发布日期】:2003-03-10
【实施或试行日期】:2003-03-10
【发布单位】:英国标准学会(GB-BSI)
【起草单位】:BSI
【标准类型】:()
【标准水平】:()
【中文主题词】:电气工程;玻璃纤维电缆;导电体;电信;通信电缆;类规范;配电电缆;光纤;规范;光波导;室内光缆;规范(验收);尺寸;电缆
【英文主题词】:Cables;Communicationcables;Dimensions;Distributioncables;Electriccables;Electricconductors;Electricalengineering;Familyspecification;Fibreoptics;Glassfibrecables;Insidecables;Opticalwaveguides;Specification;Specification(approval);Telecommunication;Telecommunications
【摘要】:TobereadinconjunctionwithBSEN60794-1-1:2002,BSEN60794-1-2:1999,BSEN60794-2:2003
【中国标准分类号】:M33
【国际标准分类号】:33_180_10
【页数】:18P.;A4
【正文语种】:英语


Product Code:SAE J3000
Title:Thermoplastic Elastomer Classification System (Cancelled Oct 2009, Superseded by J2558)
Issuing Committee:Committee On Automotive Rubber Specs
Scope:This classification system tabulates the properties of thermoplastic elastomers (TPEs) that are intended for, but not limited to, use in automotive applications.For the purposes of this document a TPE is defined as a polymeric material that, without further chemical modification, is capable of recovering from deformations quickly and forcibly and is also capable of being repeatedly softened by heating and hardened by cooling within a temperature range characteristic of the material.When the TPE product is to be used for purposed where the requirements are too specific to be completely prescribed by this classification system, it is necessary for the plurchaser to consult the supplier in advance to establish the apropriate propeties, test methods, and specification test limits.This classification system is based on the premise that the properties of TPEs can be arranged into characteristic material designations. These designations are determined by type, based on resistance to heat aging; and class, based on resistance to volume change resulting from oil immersion. Basic levels are thus established which, together with values describing additional requirements, permit complete description of the propeties of all TPEs.In all cases where provisions of this classificaiton system would conflict with those of the detailed specifications for a particular product, the latter shall take precedence.this classificaiton is based on SI units.